No products in the cart.
- You cannot add "Ethernet Shield W5100 Development board for Arduino" to the cart because the product is out of stock.
-9%
The Arduino CNC Shield makes it easy to get your CNC projects up and running in a few hours. It uses opensource firmware on Arduino to control 4 stepper motors using 4 A4988 Stepper drivers, with this shield and the Crowduino you can build all kinds of robotics or CNC projects including CNC routers,laser cutters and even pick & place machines.
Features
- GRBL 0.8c compatible. (Open source firmware that runs on an Arduino UNO that turns G-code commands into stepper signalshttps://github.com/grbl/grbl)
- 4-Axis support (X, Y, Z , A-Can duplicate X,Y,Z or do a full 4th axis with custom firmware using pins D12 and D13)
- 2 x End stops for each axis (6 in total)
- Spindle enable and direction
- Coolant enable
- Uses removable Pololu A4988 compatible stepper drivers. (A4988, DRV8825 and others)
- Jumpers to set the Micro-Stepping for the stepper drivers. (Some drivers like the DRV8825 can do up to 1/32 micro-stepping )
- Compact design.
- Stepper Motors can be connected with 4 pin molex connectors.
- Runs on 12-36V DC. (At the moment only the Pololu DRV8825 drivers can handle up to 36V so please consider the operation voltage when powering the board.)
- This CNC shield is 100% compatible with this project and will get you going in record time.
Useful Links
- Detailed Introduction and User Manual
- The Grbl wiki page can be found here: https://github.com/gnea/grbl/wiki
- The Grbl project page and software can be found here: https://github.com/gnea/grbl
Product Included:
1 x CNC Shield for Arduino